Forbo Marmoleum / Linoleum Adhseive

-Water-based adhesive formulated for linoleum.
-Also works well with cork.
-Contains no solvents.
-No VOCs.
-Resists, moisture, mildew and bacterial growth.
-Best for true linoleum tile flooring because it adheres longer.

This adhesive was formulated especially for use with true linoleum tile floors. The manufacturer classifies it as an "SBR polymer," which means it contains styrene butadiene rubber, the most common synthetic rubber.

Benefits of Forbo Linoleum Adhesive

Environmental benefits include:
· Little or no odor.
· No VOCs, dangerous solvents or formaldehyde.
· Not flammable.
· Containers are made from recycled PVC plastic.

Practical benefits include:
· Can be used on porous and sealed surfaces.
· Designed for Forbo linoleum.

Coverage:
One gallon of this adhesive is enough for 150 square feet of flooring, using the 1/16-inch notched trowel recommended for linoleum tile. To calculate the number of gallons needed, multiply the length and the width of the floor (in feet) and divide by 150. Round any fraction up to the next whole gallon.

Preparation:
When applying over concrete, or over any substrate with suspect moisture content, use a calcium chloride test kit to measure how much moisture is coming up into the floor. This product should be used only if the reading is below 5 pounds per 1,000 square feet in 24 hours. Some flooring products may have lower limits.

-Set heating or air conditioning to 68°F for 72 hours before and after installation.
-Subfloor must be free of dust, dirt, wax, paint, old adhesive residue, sealers and other foreign matter.
-72 hours before installation, bring linoleum into the heated space to acclimate.

Application:
Use a square-notch trowel with teeth 1/16 inch high, wide and apart. Replace trowel with each new bucket of adhesive. Spread adhesive on only a small area at a time. After placing a few tiles, immediately roll them in both directions with a 100-pound floor roller. Keep lid on can when not in use.

Drying:
Approximately 24 hours. Do not allow heavy traffic or roll heavy objects across the floor for 72 hours.


Cleanup:
With a clean, damp cloth, wipe off excess adhesive before it dries.


Maintenance:
Don't wash floor for at least 72 hours to allow adhesive to cure properly.